is your cylinder gap ok? for it to happen that quick sounds like it might be throwing more out the cylinder than it should?
that said, I did have one of those, and did have similar problems getting the cylinder out. grease did help. although my gun would still rotate the cylinder itself, it was just stripping it that suffered.
it may also be that your hand is worn, and so slipping off the cylinder when a bit of force is applied? or have I misunderstood and if you don't help it, you are just not able to get it to carry on pulling back without helping the cylinder rotate?
When guns are outlawed, only Outlaws will have guns
Cylinder gap is miniscule, and very little side blast; the fouling is more at the rear of the cylinder around the hammer. No spots on the cylinder pin at all as I always keep things spotless. I'm thinking of trying to file those grooves into the pin to see if it spreads the grease around it. I have checked the hand along with the bolt and it locks up very well and the timing is spot on. When the gun is clean I can simply cock the hammer with my thumb. But once it has shot a couple of shots it seems to clog up and I have to assist it with my other hand.
I may try lard and see what happens.
Never argue with an idiot, he will drag you down to his level and beat you with experience.
I shot one of these and took a Bronze at the BP world championships with it. Absolutely agree about the binding on the arbor and it’s something that only seems to affect the Pietta. Neither my current repro (Hege) or the originals do it. Having said that, I only use 15 grains in the repro and 17 in the original. Fill the void with Sainsburys semolina to just less than ball diameter and press ball home so it sits just lower than cylinder face. That way, you can only get a thin ring of grease around the ball so shooting it is quite clean.
Not me Simon; I just load a charge of powder followed by a wad and then the ball. I'm not looking for lube over the ball, just lube around the cylinder pin so that I can pull it out when I need to recharge the cylinder.
Never argue with an idiot, he will drag you down to his level and beat you with experience.
I have a Pietta 1858 revolver. I have not had any cylinder binding with mine. I load with about 25 grains of Henry Krank fine powder, a felt wad and ball. I usually slather a bit of Wonder Lube or Blue and Grey pistol patch over the ball. I don't take the cylinder out to load, but load on the gun. After three or four cylinders full I take the cylinder out and wipe the fouling off. I do take the cylinder out before I leave the range though, as I have had trouble with the cylinder pin seizing up if left for a while after shooting.
Regards
Peter.
PeterN wrote: ↑Tue Mar 29, 2022 7:27 pm
I have a Pietta 1858 revolver. I have not had any cylinder binding with mine. I load with about 25 grains of Henry Krank fine powder, a felt wad and ball. I usually slather a bit of Wonder Lube or Blue and Grey pistol patch over the ball. I don't take the cylinder out to load, but load on the gun. After three or four cylinders full I take the cylinder out and wipe the fouling off. I do take the cylinder out before I leave the range though, as I have had trouble with the cylinder pin seizing up if left for a while after shooting.
Regards
Peter.
is yours stainless?
When guns are outlawed, only Outlaws will have guns