Reloading for an Underlever..

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
User avatar
falco67
Site Supporter Since 2015
Posts: 287
Joined: Tue Aug 06, 2013 8:37 am
Location: UK

Re: Reloading for an Underlever..

#21 Post by falco67 »

I did think that, but its 1.600 which it should be, as far as I am aware.
Top
User avatar
phaedra1106
Past Supporter
Posts: 3390
Joined: Wed Feb 08, 2012 9:37 pm
Location: Just outside Sacriston (the nice bit!)
Contact:
Contact phaedra1106

Re: Reloading for an Underlever..

#22 Post by phaedra1106 »

Load it to the cannelure, 1.610" is the max Saami length (min is 1.535") anywhere in between is fine. COAL for my 200gr is 1.535" and my 245gr is 1.583"
There's room for all Gods creatures, next to the mash and gravy :)
Top
User avatar
falco67
Site Supporter Since 2015
Posts: 287
Joined: Tue Aug 06, 2013 8:37 am
Location: UK

Re: Reloading for an Underlever..

#23 Post by falco67 »

phaedra1106 wrote:Load it to the cannelure, 1.610" is the max Saami length (min is 1.535") anywhere in between is fine. COAL for my 200gr is 1.535" and my 245gr is 1.583"
Thanks

crimping to the bullet canulure gives me a COAL of 1.557 :good:
Top
Post Reply

Return to “Reloading and Ammunition”

Who is online

Users browsing this forum: No registered users and 11 guests