6.5x47 load development............at 600yds

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
User avatar
Pete
Past Supporter
Posts: 2950
Joined: Tue Sep 15, 2015 8:48 am
Home club or Range: NRA Bisley
Contact:

6.5x47 load development............at 600yds

#1 Post by Pete »

DSCN5478 M4 2.46 2.48 2.jpg
Last Thursday, almost flat calm, mist held us up for half an hour, with a threat of thunder.
Three 5-shot groups at 600yds, the first two using RS52, and the third, RS60
2.46= 38.0grains RS52, then dialled two minutes right
2.48= 38.3 grains RS52 (1 flyer), and last, dialled two minutes down
2.60= 40.1 grains RS60

2.48 hits the spot with 4 shots in <1/2 MOA. MV's all in the region of 2900fps.

Rifle is a Savage F/TR re-barrelled in 6.5 with a 28" Bergara 8 twist s/steel straight taper.
Bullets were 136 grain Scenar "L", Lapua brass, KVB 223-M primers, COL 69.5mm.

Much more fun with the electronics than mucking about on Short Siberia................ :run:

Pete
"Tantum religio potuit suadere malorum" Lucretius
You're offended? Please explain why your inability to control your emotions translates into me having to censor my opinions....
User avatar
WelshShooter
Site Supporter Since 2016
Posts: 1804
Joined: Wed Jun 25, 2014 9:45 pm
Contact:

Re: 6.5x47 load development............at 600yds

#2 Post by WelshShooter »

Good shooting Pete! I shot my 6.5x47 Lapua today as well, but only at 100m. My 123gr bullet load is also 40.0gr of RS60 and that gets me an average velocity of 2,970 fps.
User avatar
Pete
Past Supporter
Posts: 2950
Joined: Tue Sep 15, 2015 8:48 am
Home club or Range: NRA Bisley
Contact:

Re: 6.5x47 load development............at 600yds

#3 Post by Pete »

I already use RS52 in 6BR, 308, and 223.........looks like it'll be fine for 6.5x47 as well.

Pete
"Tantum religio potuit suadere malorum" Lucretius
You're offended? Please explain why your inability to control your emotions translates into me having to censor my opinions....
User avatar
Pete
Past Supporter
Posts: 2950
Joined: Tue Sep 15, 2015 8:48 am
Home club or Range: NRA Bisley
Contact:

Re: 6.5x47 load development............at 600yds

#4 Post by Pete »

Gotta fess up.....I only loaded the ammo for this card.......'er indoors pulled the trigger !!

Pete
"Tantum religio potuit suadere malorum" Lucretius
You're offended? Please explain why your inability to control your emotions translates into me having to censor my opinions....
Post Reply

Who is online

Users browsing this forum: No registered users and 14 guests