A load for .303 lead bullet .
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
- Site Admin
- Posts: 17375
- Joined: Fri Nov 05, 2010 7:52 pm
- Location: Wind Swept Denmark
- Contact:
Re: A load for .303 lead bullet .
New users can't access the Library.
-
- Posts: 15
- Joined: Thu Dec 20, 2018 12:06 pm
- Home club or Range: Lincolnshire Shooting Centre
Re: A load for .303 lead bullet .
He will have done neither .I will probably have to do it when I get hold of the rifle .dromia wrote:Go to front page an scroll down and click on library.
Have you slugged the rifles barrel and taken a chamber cast of the rifle to ensure that the bullets are of a suitable shape and diameter?
Who is online
Users browsing this forum: No registered users and 10 guests