Purchasing new brass advice and expectations

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Message
Author
User avatar
Mattnall
Site Supporter Since 2016
Posts: 2858
Joined: Wed Mar 06, 2013 5:32 pm
Home club or Range: Harlow TAC, NRA, BSRC
Contact:

Re: Purchasing new brass advice and expectations

#11 Post by Mattnall »

I found Lapua 223 brass was very soft, I was always trimming more off than I do with Winchester brass and I wasn't pushing them very hard.
Arming the Country, one gun at a time.

Good deals with Paul101, Charlotte the flyer, majordisorder, Charlie Muggins, among others. Thanks everybody.
hitchphil
Posts: 903
Joined: Thu Jul 05, 2012 11:56 pm
Home club or Range: Bisley - Mostly
Contact:

Re: Purchasing new brass advice and expectations

#12 Post by hitchphil »

i found the primer pockets in GGG were more variable than RWS or PPU so some were hard to press in & a very few so easy i was worried they would come out on firing.

best brass i got was RWS, we salvaged several k of it that now rotates abt younger shooting clubs & HPS who reload it. only after 5-6 loads did we find a very few necks splitting so now they are all annealed each time. i bought a salt bath annealer off someone on here goodjob & anneal the necks every time now & they are working to 15+ relaods. first 2 loads needed neck trim after that they seem to settle down.

I make a 308W CIP equivalent for cost saving - i find case prep has least effect on accuracy vs bullet type or charge..... its also laborious & boring! so I do them in batches of 100 then load them in batches of 50.

HPS own head stamp brass was MEN boxer, that is also very good.
Quality control of Scottish Ethanol. & RDX/HMX

& my fav chemical is :-) 1,3,7-trimethylxanthine.......... used to kill frogs.... but widely consumed & in vast quantities by the French? Eh?
Post Reply

Who is online

Users browsing this forum: No registered users and 8 guests