Does anyone happen to know what thread the Stoeger M3K stock bolt is?
It verniers at 9.76mm/0.384" but is not M10.
I've included a picture with an M10 thread (bottom) for comparison.
The stock thread is noticeably finer than M10 so maybe imperial?
Stoeger M3K stock bolt thread?
Moderator: dromia
Forum rules
Should your post be in Grumpy Old Men? This area is for general shooting related posts only please.
Should your post be in Grumpy Old Men? This area is for general shooting related posts only please.
Re: Stoeger M3K stock bolt thread?
Addition:
The thread is 28 TPI
The thread is 28 TPI
-
- Past Supporter
- Posts: 213
- Joined: Wed Oct 05, 2016 3:45 pm
- Home club or Range: Cotswold Rifle Club
- Contact:
Re: Stoeger M3K stock bolt thread?
I have seen 3/8 28tpi taps.
I think they were used on electrical fittings.
Stoeger is American so it is likely an Imperial thread
I think they were used on electrical fittings.
Stoeger is American so it is likely an Imperial thread
Re: Stoeger M3K stock bolt thread?
I have emailed Stoeger so lets see how good their technical department are
Re: Stoeger M3K stock bolt thread?
I just got a reply back from MOA precision and apparently the thread is M10 1mm.
A quick gander on ebay brings a single bolt in at 8 quid
A quick gander on ebay brings a single bolt in at 8 quid
- Ovenpaa
- Site Supporter Since 2015
- Posts: 24680
- Joined: Fri Nov 05, 2010 8:27 pm
- Location: Årbjerg, Morsø DK
- Contact:
Re: Stoeger M3K stock bolt thread?
I was about to say M10 fine :)
Will the bolt on ebay do the job?
Will the bolt on ebay do the job?
Re: Stoeger M3K stock bolt thread?
Hopefully it will do the job Dave, yes.Ovenpaa wrote:I was about to say M10 fine :)
Will the bolt on ebay do the job?
I've ordered one so should be here Tuesday.
Who is online
Users browsing this forum: No registered users and 17 guests