Stainless bar stock

[Alpha1]

I'm after a piece of stainless round bar stock about a 1-1/4" OD and about 4" long.

[Andy632]

I'm after a piece of stainless round bar stock about a 1-1/4" OD and about 4" long.

Lots of it (303) but I'm in the Highlands.

[Alpha1]

Hmm I think Ill ring a local steel stockists in the morning I think they sell 3m lengths. My guess is they will charge me a arm and a leg.

[ovenpaa]

Would a length of stainless rifle barrel be of use? Just not sure if I have any as big as 32 mm as I tend to chop the chamber ends for sectioning

[Alpha1]

I want it to make a 38/357 case holder for the LeWilson trimmer if the bore is small enough I could open it up. The OD of the Wilson case holders is 26mm.

[Andy632]

Hmm I think Ill ring a local steel stockists in the morning I think they sell 3m lengths. My guess is they will charge me a arm and a leg.

Check out any Marine workshops.

If stuck I can post you a bit, just need the postage.